CarbonX™ Carbon Fiber Reinforced PC/ABS Filament
New

CarbonX™ Carbon Fiber Reinforced PC/ABS Filament

$110.00
Product Code: CF-PC-ABS
Stock Instock

Overview

3DXTech CarbonX Carbon Fiber- Polycarbonate / ABSThe Carbon Fiber - Polycarbonate/ ABS 3D printing filament by 3DX Tech is great material for high stiffness, high heat, structural components that offer excellent surface quality, and dimensional stabi...

3DXTech CarbonX Carbon Fiber- Polycarbonate / ABS


The Carbon Fiber - Polycarbonate/ ABS 3D printing filament by 3DX Tech is great material for high stiffness, high heat, structural components that offer excellent surface quality, and dimensional stability. It has been Specially formulated to for improved properties while retaining it's ease of printing.


Manufacturers recommended settings:

• Hot end: 280- 300 Degrees

• Heated Bed: 100- 130

• Bed Prep: PEI Sheet or Tape, Glue stick on clean glass, ABS/Acetone Slurry 

• Nozzle: We strongly recommend a 0.4mm orifice or larger using one of our A Hardened Nozzles

• Layer Height:  Ideal layer height is 60% of nozzle diameter.  We do not recommend printing layers below 0.25mm with carbon fiber grades.  Lower than 0.25mm may create too much back pressure in the hot end and result in poor feeding, jams, drive gear clicking, and eating a notch into the filament

• Support:  Our Aquatek water soluble support works great to create complex parts.


Our finding so far while printing on the Creatbot F430 is that we can achieve good adhesion with Dimafix on a Carbon Fiber build plate. Filament requires more spring tension than normal due to the hardness of the filament which can cause slipping. Layer heights of 0.2mm are easily achieved. 

 


    


Write a review

Note: HTML is not translated!

Rating Bad           Good
Captcha